TP17S1200LCD

Specification
Brand
Tripp Lite
Model
SMART1200LCD
Output Volt Amp Capacity (VA)
1200
Output kVA capacity (kVA)
1.2
Output Watt Capacity (watts)
700
Nominal Output Voltage(s) Supported
115V; 120V
Frequency compatibility
60 Hz
Output voltage regulation (line mode)
-18% +8%
Output voltage regulation (Battery mode)
115V (+/- 5%)
Built-in UPS output receptacles
8 5-15R outlet(s)
Basic PDU options
PDU1215(1U / 13 5-15R outlets);PDUNV(1U / 2 C19 12 C13 outlets);PDU1415(0U / 14 5-15R outlets);PDUV15(0U / 12 5-15R outlets)
Metered PDU options
PDUMH15(1U / 13 5-15R outlets);PDUMH15AT (1U / 8 5-15R outlets)*;PDUMV15(0U / 16 5-15R outlets)
Switched PDU options
PDUMH15ATNET(1U / 8 5-15R outlets)*;PDUMV15NET(0U / 16 5-15R outlets)
External PDU redundancy options
*Auto Transfer Switch features utilizing the secondary PDU input cord are compatible with Smart Online UPS models only
Output AC waveform (AC mode)
Sine wave
Output AC waveform (battery mode)
PWM sine wave
Rated input current (at maximum load)
7A
Nominal Input Voltage(s) Supported
120V AC
UPS input connection type
5-15P
Input circuit breaker
10A
UPS Input cord length (ft.)
6
UPS Input cord length (m)
1.8
Recommended Electrical Service
15A 120V
Full load runtime (minutes)
4 min. (700w)
Half load runtime (minutes)
12 min. (350w)
DC system voltage (VDC)
24
Battery recharge rate (included batteries)
Less than 4.5 hours from 10% to 90%
Voltage regulation description
Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 75 to 147
Overvoltage correction
Input voltages between 128 and 147 are reduced by 12%
Undervoltage correction
Input voltages between 93 and 107 are boosted by 14%
Severe undervoltage correction
Input voltages between 75 and 92 are boosted by 30%
LED Indicators
Front panel LCD display
Front panel LCD display
Backlighted LCD screen indicates input voltage 5-bar battery charge level overload AVR on battery and replace battery status; LCD screen rotates for rack/tower viewing
Alarms
Audible alarm indicates power-failure low-battery and overload status; alarm can be disabled using PowerAlert software
Alarm cancel operation
Power-fail alarm can be silenced using alarm-cancel switch; once silenced alarm will re-sound to indicate low-battery status
Switches
2 Switches control off/on power status and alarm-cancel/self-test operation; dimmer switch controls LCD brightness
UPS AC suppression joule rating
480
UPS AC suppression response time
Instantaneous
UPS Dataline suppression
1 line TEL/DSL (1 in / 1 out); 10/100Base T Ethernet
EMI / RFI AC noise suppression
Yes
Installation form factors supported with included accessories
4 post 19 inch rackmount (mounting kit included); 2 post 19 inch rackmount (mounting kit included)
Included mounting accessory description
Pair of mounting ears enable tower and 2-4 post rackmount installation
Primary form factor
Rackmount
UPS / Power Module dimensions in primary form factor (height x width x depth / inches)
3.5 x 17.2 x 10.5
UPS / Power Module dimensions in primary form factor (height x width x depth / cm)
8.9 x 43.8 x 26.7
Installed whole system maximum rack depth (inches)
10.5
Installed whole system maximum rack depth (cm)
26.7
Installed whole system total rack space height (rack spaces)
2U
Secondary form factor
Tower
Installed whole system dimensions in secondary form factor (height x width x depth / inches)
17.2 x 3.5 x 10.5
UPS dimensions in secondary form factor (height x width x depth / cm)
43.8 x 8.9 x 26.7
UPS / Power Module weight (lbs)
29.4
UPS / Power Module weight (kg)
13.3
UPS Shipping dimensions (height x width x depth / inches)
7.5 x 15 x 21.5
UPS Shipping dimensions (height x width x depth / cm)
19 x 38.1 x 54.6
Shipping weight (lbs)
29.4
Shipping weight (kg)
13.3
UPS housing material
ABS
Operating Temperature Range
+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature  Range
+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity
0 to 95% non-condensing
AC mode BTU / hr. (full load)
179.1
Battery mode BTU / hr. (full load)
487.5
Communications interface
USB (HID enabled); DB9 Serial
Network monitoring port description
Supports detailed monitoring of UPS and site power conditions
PowerAlert software
Free download from www.tripplite.com
Communications cable
USB and DB9 Serial cabling included
WatchDog compatibility
Supports Watchdog application OS and hard-reboot restart options for remote applications
Transfer time
2-4 milliseconds
Low voltage transfer to battery power (setpoint)
75
High voltage transfer to battery power (setpoint)
147
Cold Start (startup in battery mode during a power failure)
Cold-start operation supported
UPS Certifications
Tested to UL1778 (USA); Tested to CSA (Canada); Tested to NOM (Mexico); Meets FCC Part 15 Category B (EMI)
Product Warranty Period (U.S. Canada & Puerto Rico)
3-year limited warranty
Connected Equipment Insurance (U.S. Canada & Puerto Rico)
$250000 Ultimate Lifetime Insurance
Note
--